Influence of Separating Fibrous Seed Mass to Fractions to Quality
T.A.Ochilov1, B.B.Akhmedov2, T.A.Toyirova3, Sh.S.Mengnarov4, J.T.Xasanov5
1Prof. Ochilov Tulkin Ashurovich*, Faculty Technology of Light Industry and Design, Tashkent, Institute of Textile and Light Industry, Uzbekistan
2Prof. Akhmedov Bahodir Buriyevich, Faculty Technology of Light Industry and Design, Tashkent, Institute of Textile and Light Industry, Uzbekistan.
3Prof. Toirova Tursunoy Abdugapirovna, Faculty Technology of Light Industry and Design, Tashkent Institute of Textile and Light Industry, Uzbekistan.
4Shuxrat Soatovich Mengnarov, Faculty Technology of Light Industry and Design, Tashkent Institute of Textile and Light Industry, Uzbekistan.
5Xasanov Jo’rabek Toshboy o’g’li, Faculty Technology of Light Industry and Design, Tashkent Institute of Textile and Light Industry, Uzbekistan.
Manuscript received on April 02, 2020. | Revised Manuscript received on April 15, 2020. | Manuscript published on May 30, 2020. | PP: 200-202 | Volume-9 Issue-1, May 2020. | Retrieval Number: F7834038620/2020©BEIESP | DOI: 10.35940/ijrte.F7834.059120
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: This article describes the fourth type of medium-fiber Hampor, currently widely used in the Surkhandarya region, the lengnth is about 160-170 mg, 171-180 mg, 181-190 mg, 191-200 mg, 201-205 mg, 206-210 mg was divided into fractions by mass of fibers, the LKM equipment was cleaned of fine and dirty particles in the laboratory of the ginnery, DL-10 was isolated from the fiber on the ginning equipment, and the physical and mechanical properties of the seeds, and 20.0 texts were made from the cotton fiber at the “Sherli” small-scale spinning device at the “Pakhtasanoat Research Center” AC. Physical and mechanical properties of the yarn, i.e. quadratic inequality of linear density, quadratic inequality by the number of twists, quadratic inequality in strength, durability, comparative shear strength, elongation at break, elongation in discontinuity was identified with the help of modern equipment and the spinning plant was able to split fibers into fractions for the production of high quality yarn, optimal versions were proposed.
Keywords: Fiberglass mass, Fraction, Ginning, Thinness, Stiffness, Misalignment, Variation coefficient.
Scope of the Article: Nanotechnology