LabVIEW Based Temperature Controller using Arduino
V. Prakasam1, Vikas Kumar Tiwari2, K.R. Anudeep Laxmi Kanth3
1V. Prakasam, Department of ECE,Vignan Institute of Technology and Science, Deshmukhi, Hyderabad, Telangana, India.
2Vikas Kumar Tiwari, Department of ECE, Vignan Institute of Technology and Science, Deshmukhi, Hyderabad, Telangana, India.
3K.R. Anudeep Laxmi Kanth, Department of ECE, Vignan Institute of Technology and Science, Deshmukhi, Hyderabad, Telangana, India.
Manuscript received on November 20, 2019. | Revised Manuscript received on November 28, 2019. | Manuscript published on 30 November, 2019. | PP: 6830-6835 | Volume-8 Issue-4, November 2019. | Retrieval Number: D5230118419/2019©BEIESP | DOI: 10.35940/ijrte.D5230.118419
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The main aim of this paper provides to existing two types of temperature control system that are automatic temperature control system and manual control system using LABVIEW and Arduino. In this paper, we are designated LABVIEW based temperature controller using Arduino. In this paper, we are operated 5 volt cooling fan when the temperature goes to above the fixed point. Here, we will use LM35 temperature sensor and we are using three different LEDs or single RGB LED to indicate the range of temperature. The design and working operation will classified into three different categories that are first one is when the temperature is above the mark (set) point, in this case the Red LED will glows, second one is when the temperature exists between higher mark point and lower mark (set) point, in this case the Blue LED will glows and third one is when the temperature set the below set point, in this case the Green LED glows. The temperature reading also stored in Microsoft excel sheet. Here we used LABVIEW 2017 software version for designing temperature controller system. The remaining software’s also used for designing temperature controller system but the LabView is the simplest way of remaining all software’s.
Keywords: LABVIEW, Arduino, Temperature, LM35, RGB, And LED.
Scope of the Article: Logic, Functional Programming and Microcontrollers for IoT.