Analysis and Design of RF Filters with Lumped and Distributed Elements
G. T. Bharathy1, S. Bhavanisankari2, T. Tamilselvi3, G. Bhargavi4
1G. T. Bharathy, Department of Electronics and Communication Engineering, Jerusalem College of Engineering, Chennai (Tamil Nadu), India.
2S. Bhavanisankari, Department of Electronics and Communication Engineering, Jerusalem College of Engineering, Chennai (Tamil Nadu), India.
3T. Tamilselvi, Department of Electronics and Communication Engineering, Jerusalem College of Engineering, Chennai (Tamil Nadu), India.
4G. Bhargavi, Department of Electronics and Communication Engineering, Jerusalem College of Engineering, Chennai (Tamil Nadu), India.
Manuscript received on 13 July 2019 | Revised Manuscript received on 09 August 2019 | Manuscript Published on 29 August 2019 | PP: 38-42 | Volume-8 Issue-2S5 July 2019 | Retrieval Number: B10090682S519/2019©BEIESP | DOI: 10.35940/ijrte.B1009.0782S519
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: Radio frequency (RF) and microwave filters characterize a class of electronic filter, intended to function on signals in the frequency range between megahertz to gigahertz. A Lumped element RF filters is a passive device whose size across any dimension is much smaller than the operating wavelength so that there is minimal change in phase of waveform between the input and output connections. RF filters can also be designed using distributed elements in which all the inductors and the capacitors are replaced by the open and short circuit stubs. This paper concentrates on an analysis and design of low pass filter with the help of only lumped elements and a high pass filter with both lumped and distributed elements.
Keywords: Lumped Elements, RF Filters, LC Components, Stubs, Advanced Design System (ADS).
Scope of the Article: Low-power design