Baseband Signal Generation for Multi-Function Phased Array Radar
M.Shanmuga Priya1, M.Uma Saranya2, S.Anitha Kumari3, S.Tamil Selvi4
1M.Shanmuga Priya*, UG Student, Department of ECE, National Engineering, Kovilpatti, India.
2M.Uma Saranya, UG Student, Department of ECE, National Engineering, Kovilpatti, India.
3S.Anitha Kumari, UG Student, Department of ECE, National Engineering, Kovilpatti, India.
4S.Tamil Selvi, Professor, Department of ECE, National Engineering, Kovilpatti, India.
Manuscript received on April 02, 2020. | Revised Manuscript received on April 15, 2020. | Manuscript published on May 30, 2020. | PP: 416-419 | Volume-9 Issue-1, May 2020. | Retrieval Number: F9536038620/2020©BEIESP | DOI: 10.35940/ijrte.F9536.059120
Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The multi-function phased array radar (MPAR) is used for weather monitoring, air-traffic control requirements and non-cooperative elements monitoring in a parallel manner. The amplitude of the radio frequency signal is varied depending on the location of the target from the radar. The proposed work generates a signal which is used as a input for RF transmitter of Multifunction Phased Array Radar. To achieve this MPAR requirement, the in-phase and quadrature-phase samples are generated for a high data rate using MATLAB and then VHDL output was obtained from Xilinx for QPSK and QAM modulation techniques.
Keywords: Multifunction Phased Array Radar (MPAR), QAM, QPSK, MATLAB, VHDL.
Scope of the Article: Signal Control System & Processing