Retrofitting Measures of Guntupalli Caves, West Godavari District, Andhra Pradesh, India, using Reinforced Rock Technique
S.R.K. Reddy1, A. Satish Kumar2, P. Urmila3
1Dr. S.R.K. Reddy, Professor, Department of Civil Engineering, Gudlavalleru Engineering College, Gudlavalleru (Andra Pradesh), India.
2A. Satish Kumar, Assistant Professor, Department of Civil Engineering, Aditya Engineering College, Surampalem (Andra Pradesh), India.
3P. Urmila, Assistant Professor, Department of Civil Engineering, NRI Institute of Technology, Agiripalli (Andra Pradesh), India.
Manuscript received on 20 August 2019 | Revised Manuscript received on 11 September 2019 | Manuscript Published on 17 September 2019 | PP: 1280-1283 | Volume-8 Issue-2S8 August 2019 | Retrieval Number: B10530882S819/2019©BEIESP | DOI: 10.35940/ijrte.B1053.0882S819
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: India is known for its rich, diversified and cultural properties. Assessment, evaluation and maintenance of ancient and historical monuments is a major concern today. Most of the historical structures which were built in earlier 1950s are now found unsafe if cheeked by present codes. Disintegration / deterioration due to continuous weathering processes and bitter failure examples from recent natural hazards reveal the importance of restoration / retrofitting measures. In this paper, a case study on Guntupalli Caves, one of the finest testimonials of Buddhist Heritage, located in eastern ghat region of A.P. state, India, is taken up. The important monuments located in the study area are rock cut temples, monasteries and ruined Mandapa. Rock samples of different monuments are collected and tested in the laboratory and from test results, it is observed that the compressive and bending stress values are low and found vulnerable against any further loading. A new retrofit concept “Reinforced Rock” technique is adopted by introducing steel flats / bars in tension zone of rock samples. Test results have shown that compression and bending stress values are increased by two to four times compared with the results of those obtained in rock samples without reinforcement.
Keywords: Rock Cut Monument, Retrofit Technique, Reinforced Rock, Bending Stress.
Scope of the Article: Civil and Environmental Engineering